Finishing Rings with CA (Superglue)
Wooden rings benefit from a good tough, protective coating both for visual appeal and to keep them safe from scratches and knocks. CA (superglue) is perfect for this. It dries very hard, very tough and super glossy.
The process for finishing a ring is pretty easy. It's as simple as building a few layers on the ring, sanding flat and then polishing to a shine. The ring featured below only took ten minutes from start to finish, which is helped by using an accelerator spray on the CA, but even without that you can do the whole job in well under an hour.
Before starting, the ring has been sanded to 1500 grit, dusted and cleaned with white spirit, then mounted on my turning jig (OK, OK, it's a power drill clamped to my bench - but it works!). This process can be used for metal rings too - a coat of CA will protect a gilded finish, or stop copper from tarnishing.
For a change, I've made a video of the process rather than photos. Here we go, apologies in advance for dodgy editing…
The process for finishing a ring is pretty easy. It's as simple as building a few layers on the ring, sanding flat and then polishing to a shine. The ring featured below only took ten minutes from start to finish, which is helped by using an accelerator spray on the CA, but even without that you can do the whole job in well under an hour.
Before starting, the ring has been sanded to 1500 grit, dusted and cleaned with white spirit, then mounted on my turning jig (OK, OK, it's a power drill clamped to my bench - but it works!). This process can be used for metal rings too - a coat of CA will protect a gilded finish, or stop copper from tarnishing.
For a change, I've made a video of the process rather than photos. Here we go, apologies in advance for dodgy editing…